Filter
Top Products
11. LIST OF ERROR CODES
73
BAS-311H
Work clamp-related errors
Code Cause of error and remedy
E300
Work clamp home position cannot be detected. Problem with work clamp motor or poor work clamp home
position sensor connection.
Turn off the power, and then check that connectors P19, P23 and P8 on the main P.C. board are properly
connected.
E301
Work clamp raised or lowered position cannot be detected.
Turn off the power, and then check if there are any problems in the work clamp vertical direction. Turn off the
power, and then check that connectors P19 and P23 on the main P.C. board are properly connected.