Filter
Top Products
8. SEWING
BAS-311H
51
8. SEWING
WARNING
Do not allow any liquids to get onto this sewing machine, otherwise fire, electric shocks or operating problems may
occur.
If any liquid gets inside the sewing machine (machine head or control box), immediately turn off the power and
disconnect the power plug from the electrical outlet, and then contact the place of purchase or a qualified
technician.
CAUTION
Turn off the power switch at the following times.
If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.
• When threading the needle
• When replacing the bobbin and needle
• When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
8-1. Sewing
1. Turn on the power switch.
2. Press the or key (1) to select the sewing program
number that you would like to use.
* Refer to "7-4. Reading additional sewing data" for
details on reading sewing data from an SD card.
3. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, lower the work clamp
(3) before depressing the start switch (2).)
• The feed mechanism will move to the home position.
4. Place the material under the work clamp (3).
5. Depress the foot switch to the 1st step.
(If using a two-pedal foot switch, depress the work
clamp switch (4).)
• The work clamp will be lowered.
6. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, depress the start switch
(2).)
• The sewing machine will start sewing.
7. After sewing is completed, the thread trimmer will
operate, and then the work clamp (3) will be raised.
Use a work clamp which will hold the material securely
so that it does not slip. If the material slips when using
the standard work clamp and feed plate, process them
so that the material does not slip.
3109B
4441Q
1st step
2nd step
4979Q
3110B