Filter
Top Products
4. PREPARATION BEFORE SEWING
27
BAS-311H
4-6. Starting up
Before turning on the power switch, check that the
needle bar is at the needle up stop position.
Turn the pulley (1) in the direction of the arrow until the
ridge at the bottom of the thread take-up (2) is aligned with
the index mark.
1. Turn on the power switch.
The POWER indicator (3) will illuminate, and the model
name will appear in the tension value display (4) and the
specifications will appear in the section No. display (5).
Specifications Display
Medium-weight
materials
Motor-driven work
clamp
－03S
Medium-weight
materials
Pneumatic work
clamp
－03A
Heavy-weight
materials
Motor-driven work
clamp
－05S
Heavy-weight
materials
Pneumatic work
clamp
－05A
Seatbelts
－07A
After this, if there is any sewing data registered, the
program number will flash in the PROGRAM No. display
(6). However, no sewing data is recorded at the time of
shipment from the factory, and so "---" will appear at this
time.
For details on the sewing data reading method, refer to
"7. Using SD cards".
3068B
Aligned
2979B
3151B 3152B 3153B 3154B 3155B
3349B