Filter
Top Products
7. USING SD CARDS
50
BAS-311H
7-4. Reading additional sewing data
1
Select the “ r 1” SD data read/write mode.
(Refer to “7-3. Preparation for reading and writing data”.)
・ The number of the additional sewing data in the SD
memory card folder will appear in the tension display.
(The initial value displayed is “ALL”.)
2
Press the
or key to select the number for the
additional sewing data that you would like to be read
(ALL, 100 to 999).
・ When “ALL” is displayed, all of the additional sewing
data will be read at once.
・ Only the data in the SD card folder corresponding to
the additional sewing data number will be displayed. (If
there is not a single item of data in the folder, “---“ will
be displayed.)
3
While reading
The number for the additional
sewing data number which is
currently being read will appear in
the tension value display.
Press the ENTER key.
・ The buzzer will sound and the selected additional
sewing data will be read from the SD card and copied
into the sewing machine's internal memory.
・ If no additional sewing data exists, an error buzzer will
sound.
4
When the display returns to the status in step 1, reading
of the additional sewing data is complete.
・ If you would like to use any other read/write modes,
press the
or key to select the mode and then
run it.
5
Ending read/write mode
TEST indicator switches off
Press the TEST key.
* Contact the place of purchase for information on other reading and writing modes.
3098B
3099B
2414B
2657B 3100B
3101B
For example, if the additional sewing
data to be read is for program No. 100
2404B