Filter
Top Products
UPPER THREADING
28
f
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
g
Holding the thread with both hands, slide
the thread into the grooves on the thread
guide plate.
a Thread guide plate
h
While holding the thread in your right
hand, use your left hand to pull the thread
toward the threading path cover, then pass
it along the thread path as shown in the
illustration.
Be sure to pass the thread along the right
side of the thread path guide.
a Threading path cover
b Thread path guide
i
Pull the thread under the thread path guide.
a Thread path guide
j
Pull back up the thread along the left side of
the thread path guide to the top left corner
of the threading path cover.
a Top left corner
b Threading path cover
k
Pull the thread back down to the needle bar
along the left side of the thread path guide.
* Make sure the thread is hooked at the top corner
and positioned behind the transparent front cover.
a Thread take-up lever check window
b Transparent front cover
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
• Use the spool cap (large, medium, or small)
that is closest in size to the thread spool. If a
spool cap smaller than the thread spool is
used, the thread may become caught in the slit
on the end of the spool and cause the needle
to break.
a
1
a
b
Memo
Look through the thread take-up lever check
window and check that the thread is correctly
fed through the take-up lever, turning the
handwheel toward you.
a
(A)
a
(B)
b
a
(C)
b
a
a
b
a Take-up lever b Thread
a
b