Filter
Top Products
Remote Command Center Address Setting | en 11
Bosch Security Systems, Inc. Installation and Operation Guide F.01U.078.098 | 3.0 | 2011.11
7 Address Setting
Each FMR-1000-RCMD connected to the Option Bus of the FPA-1000 must be set to a unique
Option Bus address ranging from 16 to 23. The devices must also be programmed at the
control panel (refer to FPA-1000 Installation and Operation Guide (P/N F.01U.173.607).
The address is set using the DIP switches at the main board of the annunciator unit. Refer to
Table 7.1.
Figure 7.1 Address Setting
Table 7.1 DIP Switch Function
The DIP switch 4 allows for locking the control keys (drill, reset and silence) in OFF position
and for locking all keys in ON position.
The DIP switch 5 enables the device’s key lock in OFF position and bypasses the key lock in
ON position.
8 Programming
All Remote Annunciators and Remote Command Centers have to be configured as elements
connected to the Option Bus.
The FPA-1000 enables various programming approaches:
– On-site at the front panel to program another panel, but not all parameters can be
programmed
– On-site through a Web server using a laptop (connected to the panel with CAT5 cable)
– Remote, using a Web page and a dial-up connection
Option Bus
Address
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5
16 OFF OFF OFF OFF position:
Control keys
are locked.
ON position:
All keys are
locked.
OFF position:
Key lock
active.
ON position:
Key lock
bypassed.
17 ON OFF OFF
18 OFF ON OFF
19 ON ON OFF
20 OFF OFF ON
21 ON OFF ON
22 OFF ON ON
23 ON ON ON
YG
P7
P3
GNDPWR+
ON DIP
1 2 3 4 5
ON DIP
1 2 3 4 5
ON
OFF
16
17
18
19
ON DIP
1 2 3 4 5
ON
OFF
ON
OFF
ON DIP
1 2 3 4 5
ON DIP
1 2 3 4 5
ON
OFF
ON DIP
1 2 3 4 5
ON
OFF
20
21
22
23
ON DIP
1 2 3 4 5
ON
OFF
ON
OFF
ON DIP
1 2 3 4 5
ON DIP
1 2 3 4 5
ON
OFF
ON DIP
1 2 3 4 5
ON
OFF
NOTICE!
Each Option Bus device must have its own address, and each address can support only one
device. Ensure that there are no duplicate addresses on the bus.