Filter
Top Products
DS7400Xi ( 4+) Reference Guide Copyright © 2007 Bosch Security Systems, Inc. P/N: F01U035325-01 Page 57
10.30 Phone Number General Control Programming: Program Address (3155)
See Glossary (section 6.14) for further details.
10.31 Phone Number Format Programming: Program Addresses (3156-3157)
Enter the DD as a:
Select Options
DDSelect Option
D
a
t
a
D
i
g
i
t
12
0 1 2 3 4 5
1900 Hz. Data/1400 Hz. Acknowledge
1800 Hz. Data/2300 Hz. Acknowledge
BFSK, SIA, Contact ID
10 Pulses per Second (PPS)
20 Pulses per Second (PPS)
40 Pulses per Second (PPS)
0Phone Number Disabled
3/1 (no Extended Reporting)
3/1E (Extended Reporting)
1
2
3/1 with Parity 3
3/1E with Parity 4
4/1 5
4/2 6
BFSK 7
SIA 110 Baud
8
Contact ID 9
0
SIA 300 Baud
*0
*0, *2, and *5 are Hex values. They will display as A, C, and F
Pager
*5
Personal Dialing
*2
at the keypads.
NOTE: Phone Number 1 Format = Address
3156
Phone Number 2 Format = Address
3157
When using the DS7416i Advanced
Radio Communications Module:
Program address 3156 as:
data digit 1 = 9, data digit 2 = 1.
Program address 3157 as:
data digit 1 = 9, data digit 2 = 1.
4
Dial tone on all phone numbers**
Enter the Data Digit as a:
Select Options
210 3 5 6 7 8
Enable remote programmer call-back
Dial pulse on all phone numbers
Dial tone, switch to pulse if required
Try DS7416i first
9 *0 *1
*0 - *1 are Hex values. They will display as A - B at the keypads.
ΔΔ
= If this option is selected, see address 3153-3154.
** = Required on PBX systems
Data Dig
it
12
Send alarms via
either
DS7416i
or
digital
Enter the Data Digit as a:
Select Options 0 1 2 3 4 5 6 7 8
Dialer delay of 15 sec. on non-24H burglar alarms only**
Dialer delay of 15 sec. on 24H burglar & fire alarms only**
Send alarms via
both
DS7416i
and
digital
***
Use 110 Baud comm. for WDSRP
9 *0 *1
*0 - *5 are Hex values. They will display as A - F at the keypads.
Δ = Only applicable when using the DS7416i option.
ΔΔ = If this option is selected, see address 3153-3154.
** = These selections can only be used with systems that have only one partition.
*** = This selection must be chosen for UL Listed Requirements when using the DS7416i module.
Use 300 Baud comm. for WDSRP
*2 *3 *4 *5
Δ
ΔΔ
Δ
ΔΔ