Filter
Top Products
26
Press the “ENTER (RESET)” key.
The control will ask you to confi rm the setting with
the following screen:
Press “ENTER (RESET)” if the value is correct, or
“CANCEL (BACK)” if it is not.
D. Temperature Low Limit Differential
In any mode or screen other than an OPTION sub-
menu, press the “LOW DIFF” key.
The following screen will be displayed:
3.
4.
1.
2.
To toggle the fuel economizer on or off: Press
“ENTER (RESET)” key.
To Adjust the Heat Manager effi ciency setting:
Press the “▲” or “▼” keys until the following
screen is displayed:
Press “ENTER (RESET)” to toggle the comfort
setting between HI, MED, and LOW. See
“HeatManager Technology” section for an
explanation of the effi ciency settings.
Press “CANCEL (BACK)” to exit.
B. Viewing the Boiler Cycle History
In any mode or screen other than an OPTION sub-
menu, press the “OPTION” key.
The following screen will be displayed:
Press the “▲” or “▼” keys until the following screen
is displayed:
a.
b.
4.
1.
2.
Programming Additional Options
Note: Some additional menus may be visible that are not included in the following pages. Those menus are non-
functional and reserved for future use.
A. Changing the Heat Manager Settings
In any mode or screen other than an OPTION sub-
menu, press the “OPTION” key.
The following screen will be displayed:
Press “ENTER (RESET)” key.
The following screen will be displayed:
1.
2.
3.
Electrical Shock Hazard.
Can cause severe injury, death, or equipment damage.
Live line voltage wires and connections will be exposed
while programming the AquaSmart. Take care to touch only
the AquaSmart keypad while programming the control.
Fire, Explosion, and Burn
Hazards.
Can cause severe injury, death, or equipment damage.
Do not set the operating limits of the control outside of
those listed by the appliance manufacturer.
The temperature displayed is the current setting.
Use the “▲” and “▼” keys to select the desired
setting. Tap the button to increase or decrease the
temperature by 1°, or hold it to increase or decrease
the temperature by 5° at a time. The control will not
allow you to select out-of-range values.
Press the “ENTER (RESET)” key.
The control will ask you to confi rm the setting with
the following screen:
Press “ENTER (RESET)” if the value is correct, or
“CANCEL (BACK)” if it is not.