Filter
Top Products
R5976255
A
TLAS
CS4 (2001-03)
11-5
Inserting a Lamp Module
Never remove the cover of the lamp housing with the equipment switched on.
The following description applies if the lamp has already been removed as described above..
! Carefully insert the new lamp module into the lamp housing and push it cautiously right back
as far as it will go.
Figure 11-4
Inserting the lamp module
! Tighten first the left screw [
1
] (only the left screw, not the right one) and then the lower screw
[
2
] with an Allen key size 3mm. This plugs slowly in the plug of the lamp module.
! When the screws are tight, lower the small grip [
3
].
!
Close the lamp cover
!
Turn the screw on the lamp cover.
! Switch on power by pressing
1
.
! Switch on the lamp by pressing
Standby
or by applying the appropriate voltage to the 24V in-
terface.
Disposing a Lamp
Note that there may be laws concerning disposal and recycling of burnt-out lamps
in your country! Please contact your local authorities to get further information!