Filter
Top Products
R5976255
A
TLAS
CS4 (2001-03)
8-4
method 2:
! Press
ENTER
to activate the digits
! Push the cursor key
right
or
left
to select the changing digit.
! Push the cursor key
up
or
down
to scroll to desired digit.
! When finished press
ENTER
to confirm.
method 3
! Counting up or down by pushing the cursor key
right
or
left
.
How to find the correct values for the displayed item?
During the installation of a file with
LOAD
, the horizontal period, the total number of vertical lines
and the interlaced mode are automatically measured and filled in the menu table. These values will
be available when starting up the
EDIT
procedure of an active file.
Do not adjust these settings on an active file, they are used to identify the input
source file.
If the value for
Horizontal Total Pixels
is wrong, sampling mistakes (small vertical bars in the
projected image) will be seen in the image. Select
Total
and adjust the pixel quantity. Adjust for
zero bars (hint: if the number of bars increase, adjust in the other direction).
The
Active Pixels
determine the width of the window on the screen. This value is normally given
in the source specifications. If not, adjust until full image is displayed (no missing pixels).
Horizontal Start
gives the number of pixels between the beginning of the input signal and the start
of the video information in the signal.
The
Horizontal Period
is already filled in with the correct value of the active file.
The
Vertical Total Lines
are already filled when an active file is selected to be edited.
Active Lines
is the number of horizontal lines determining the height of the projected image. This
value is normally given in the specification of the source. If not, adjust until full image height is
displayed (no missing lines)
Vertical start
gives the number of lines between the start of the input signal and start of the image
on the screen.
Interlaced
[On] or [Off]: this selection is automatically filled when active file has to be edited. If
the image is wrong due to mismeasurement, use the
ENTER
key to toggle between [On] and [Off].
(for interlaced images, one frame contains two fields).
Read AMDS (
AMDS = automatic mode detection & synchronization)
:
During the installation of a
file with
LOAD
, the system automatically measured the horizontal period, the total vertical lines
and the interlaced mode. When selecting
Read AMDS
, the system re-measures the above indicated
items.