Filter
Top Products
R5976255
A
TLAS
CS4 (2001-03)
5-8
5.1 Power connection
5.1.1 AC Power (mains) cord connection
I
0
RC
RS 232 IN RS 232 OUT Comm. PortIEE 1394 TRIG MOUSEVIDEO S-VIDEO SDI SDO
R G B H/C V COMPUTER MONITOR AUDIO IN AUDIO IN AUDIO IN AUDIO OUTABC12
34 56
! Use the supplied power cord to connect your projector to the wall outlet.
! Plug the female power connector into the male connector [1] at the control panel.
The power input is auto-ranging from 90 to 240 VAC.
5.1.2 Fuses
For continued protection against fire hazard:
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Fuse type : T3.15 AH/250V
5.1.3 Switching on
Use the
power
switch [2] to switch on. When
'0'
is visible, the projector is switched off. When
'1'
is visible, the projector is switched on.
When switching on with the
power
switch, the projector starts in the
standby mode
. The projector
mode indication lamp is red.
5.1.4 Image projection
To start image projection:
! apply the appropriate voltage to the 24V interface. The
projector mode indication lamp
will be
green.
! press the
'Stand by'
button once on the local keypad or on the remote control. The
projector
mode indication lamp
will be green.
! press a digit button to select an input source. The
projector mode indication lamp
will be
green.
1
2