Barco ATLAS 84 CS4 Pet Fence User Manual


 
R5976255
A
TLAS
CS4 (2001-03)
5-12
Possible indication:
RGB [HS&VS] RGB analog signals, separate sync is horizontal and vertical
sync.
RGB CS RGB analog signals, separate sync is composite sync.
RGB CV RGB analog signals, separate sync is composite video or tri-
level sync.
RGB-SOG RGB analog signals, sync on green is composite sync.
COMPONENT VIDEO - CS separate sync is composite sync.
COMPONENT VIDEO component video with composite sync on Y or composite tri-
level sync on Y.
VIDEO
S-VIDEO
When using an RCVDS 05 with a 5 cable output module, connect these 5 cables
to this 5-cable input slot (slot1) of the projector.
All sources of the RCVDS can now be accepted by the projector.
5.1.11 Computer input/Monitor output
! Connect the output of the graphical card of the computer to the
computer input
of the projector
(connection < 60 cm) or insert an interface between the output of the computer and the input of
the projector.
! Connect the monitor of the computer to the monitor output of the projector.
! This monitor output is only available when the computer input is used as input.
Pin configuration of the D15 connector:
1 RED 9 loop through to monitor
2 GREEN 10 ground
3 BLUE 11 loop through to monitor
4 loop through to monitor 12 loop through to monitor
5 ground 13 sync horizontal / composite
6 ground 14 sync vertical
7 ground 15 loop through to monitor
8 ground
Slot 2 selection:
! Press the digit button
2
on the
RCU
or the local
keypad
.