Filter
Top Products
R5976255
A
TLAS
CS4 (2001-03)
10-2
10.1 Identification
To display the
Identification screen
:
! Push the cursor key
up
or
down
to highlight
'Identification'
.
! Press
ENTER
to display the Identification screen.
The Identification screen gives an overview of:
type of projector
Barco ATLAS 67 CS4 or ATLAS 84 CS4
projector address
to change the address of the projector, see
10.4 Change Projector
Address
software version
installation configuration
possible installations:
Front/Ceiling
Front/Table
Rear/Ceiling
Rear/Table
To change the
installation
configuration
follow the instructions in
chapter
baud rate
transfer speed for communication with an IBM PC (or compatible) or
MAC. The baud rate of the projector must be the same as the baud
rate of the connected computer. When there is a difference, consult
chapter
10.5 Change Baudrate PC
.
text ON
or
OFF
projector serial number
indicates the fabrication number of the projector. This number can be
useful when calling for technical assistance
projector run time
gives the total run time since the first start up. All projectors leave
the factory with a run time of approximately 24 hours.