Filter
Top Products
Function Key Programming Function Keys - Page 41
IP Office 2420 + EU24 User’s Guide Function Keys - Page 41
40DHB0002UKEG – Issue 4 (9th February 2004) Function Key Programming
HGOS+ - Set Hunt Group Out of Service
Put a specific hunt group out of service mode.
This function requires the hunt group number to be entered when programmed. The
hunt group number is then shown next to HGOS+. This function cannot be
programmed through the phone by the user.
Pressing
HGOS+ puts the hunt group out of service. Group calls then go to its out
of service fallback group if set or, if not answered, to voicemail.
[User | Digital Telephony | Advanced | Set | Set Hunt Group Out
Service]
HGOS- - Clear Hunt Group Out of Service
Returns a hunt group that has been manually put into out of service back to normal
service. Used with HGOS+ - Set Hunt Group Out of Service on page 43.
This function requires that the hunt group number is entered when programmed. This
function cannot be programmed through the phone by the user.
The hunt group number is shown next HGOS-. Pressing
HGOS- puts the group
back into normal service if in night service.
[User | Digital Telephony | Advanced | Call | Clear Hunt Group Out Of
Service]
Hold - Hold Call
Place the current external call on hold at the central office. This function is not
supported in the USA.
If no exchange slot number is specified when the function is programmed, exchange
slot 0 is used. This function cannot be programmed through the phone by the user.
Pressing
Hold is only supported if the exchange provides a Q.931 hold facility. It is
not the same as local hold provided by the telephone system.
[User | Digital Telephony | Advanced | Hold | Hold Call]
See also:
• Rtriv - Retrieve Call on page 51.
HoldCW - Hold Call Waiting
Place the current call on hold and connects any call waiting. This function is not
supported in the USA.
This function does not required any data to be entered when programmed. This
function cannot be programmed through the phone by the user.
Pressing
HoldCW places the current call on hold and connects any call waiting
without any ringing.
[User | Digital Telephony | Advanced | Hold | Hold CW]
IAuto - Automatic Intercom
Connects call to the extension without ringing.
This function requires entry of an extension number when programmed. The target
extension must be support handsfree operation. This function cannot be programmed
through the phone by the user.
Press
IAuto connects the call without any ringing at the remote extension. If the
target extension is busy or not available, the call will follow any forwarding or diversion
to voicemail set.
[User | Digital Telephony | Emulation | Automatic Intercom]