Filter
Top Products
PAGE 30 OPTIONAL EQUIPMENT (CONTINUED)
Propane Conversion Kit
(Part # 98900746)
The propane conversion kit should be installed prior to installing the heater (if not, shut off gas
and disconnect the heater from the gas line).
Items Needed For Assembly
¥ 1/4" Nutdriver ¥ 7/16" and 1/2" Open End Wrench ¥ Standard Screwdriver
¥ Phillips Screwdriver ¥ Micro (1/16") Standard Screwdriver
¥ Thread sealant ¥ Leak Testing Equipment
Packing List
¥ LP Orifice (#49 - stamped "49") ¥ LP Pilot Orifice (.016" dia. - stamped "16LP") ¥ Replacement Regulator
¥ Two Replacement Screws ¥ Regulator Gasket ¥ LP Label
Installation Instructions
1 Remove the door (see page 14).
2 Reach into the firebox and remove the rear log shelf (see the illustration below).
Make sure the two tabs
slide over the side of the
burner pan on both sides.
Rear
Log
Shelf
Position the
shelf so the
back edges
of the shelf
and burner
pan are flush.
The rear log shelf slides on and off the
burner pan assembly
Burner Pan
Assembly
Rear
Log
Shelf
NOTE: When installed, the log
shelf must maintain a parallel
3/8Ó gap to the burner pan.