Filter
Top Products
5
The "Warning-Sharp Knife" label warns operators
and service personnel of the extremely sharp knife
used to cut the tape at the end of the box sealing
operation. The label, shown in Figure 1-8, is
located on the orange knife guard between the
applying roller assembly and the buffing roller
assembly. Never operate taping head with knife
guard removed.
Before working with the taping head or loading/
threading tape, refer to Figures 3-1 and 3-2, in
Section II, to identify the knife location. Keep hands
out of these areas except as necessary to
service the taping head or to load/thread tape.
Important Safeguards (Continued)
The following labels are located on the lower taping
head. Replacement part numbers for these two
labels are listed in Section II.
The "Tape Threading Label" shown in Figure 1-9,
is attached to the left side of the lower taping head.
This label provides a convenient tape threading
diagram. More detailed tape loading and threading
information is provided in the "Operation" section of
this manual.
Figure 1-9 – Tape Threading Label
Figure 1-8 – Knife Warning Label