E6581301
11
K-4
2. Basic parameter [4/4] Sensorless vector/vector with sensor (Ɣ:Effective, -:Ineffective)
Title
Communi
cation
No.
Function Adjustment range
setting unit
(Panel/Communi
Default
setting
running
PM
control
V/f Reference
Speed
control
Torque
control
RD 0304
Dynamic braking
selection
Setting
ST-off Overload detect
1/1 0 Disabled Ɣ/Ɣ Ɣ/Ɣ Ɣ Ɣ 5. 19
Disabled ʊ ʊ
effective in trip
condition.) The
state of
QNT
trip is excluded.
Enabled
not protect
Disabled
not protect
Enabled (It isn't
effective in trip
condition )
Enabled
not protect
Disabled
not protect
RDT
RDER
0309
0.01~600.0kW 0.01/0.01 *1 Disabled Ɣ/Ɣ Ɣ/Ɣ Ɣ Ɣ 5. 19
V[R
0007 Factory default setting
0: -
1:50 Hz default setting
2:60 Hz default setting
3:Factory default setting
4:Trip clear
5:Cumulative operation time cleared
6:Initialization of type information
7:Save user-defined parameters
8:Reset of user-defined parameters
9:Cumulative fan operation time record clear
10:Acceleration/deceleration time setting 0.01
sec.~600.0 sec.
11:Acceleration/deceleration time setting 0.1
sec.~6000sec.
1/1 0 Disabled Ɣ/Ɣ Ɣ/Ɣ Ɣ Ɣ 5. 20
RUGN
0050
Registered parameter
display selection
Standard setting mode at time of activation of motor
1:Quick mode at time of activation of motor
2:Quick mode only
1/1 0 Enabled Ɣ/Ɣ Ɣ/Ɣ Ɣ Ɣ 5. 22
H
~
H
- Extended parameters Set detailed parameters shown in the following pages. - - - Ɣ/Ɣ Ɣ/Ɣ Ɣ Ɣ -
ITW
*1: Default values vary depending on the capacity. See the table of K-48.
