G-11
Network Out-of-Band Management (OOBM)
Tasks
OOBM Show Commands
The show commands for OOBM are similar to the analogous commands for
the data plane. Note that you must always include the
oobm parameter to see
the information for the OOBM interface, regardless of the context. For
instance, even from the OOBM context the
show ip command displays the IP
configuration for the data plane; to see the IP configuration of the OOBM
interface you need to use
show oobm ip.
Show OOBM
This command shows the global OOBM and OOBM port configurations.
Syntax: show oobm
Summarizes OOBM configuration information. This com-
mand displays the global OOBM configuration (enabled or
disabled), the OOBM interface status (up or down) and the
port status (enabled/disabled, duplex, and speed).
You can issue this command from any context.
For example:
ProCurve# show oobm
Global Configuration
OOBM Enabled : Yes
OOBM Port Type : 10/100TX
OOBM Interface Status : Up
OOBM Port : Enabled
OOBM Port Speed : Auto
