A SERVICE OF

logo

Open as PDF
next previous
2. Slide the print head to the open section of the paper bail as
shown below.
3. Remove the separator from the middle of the ribbon
cartridge and discard it. Then detach the ribbon guide
from the cartridge (but not from the ribbon) and turn
the ribbon-tightening knob in the direction of the arrow
to take up any slack in the ribbon.
Position the print
head here.
d-1-7-a
separator
ribbon guide
d-1-7-b
1
R
Peony Rev.C
A5 size Chapter 1
98/01/07 Pass 4
Setting Up the Printer 1-7