90 Command Groups
interface range vlan Enters the interface configuration mode to
configure multiple VLANs.
GC
mode dvlan-tunnel Enables Double VLAN tunneling on the
specified interface
IC
name Configures a name to a VLAN. IC
protocol group Attaches a
vlanid
to the protocol-based VLAN
identified by
groupid
.
VLAN
protocol vlan group Adds the physical unit/port interface to the
protocol-based VLAN identified by
groupid
.
IC
protocol vlan group all Adds all physical unit/port interfaces to the
protocol-based VLAN identified by
groupid
.
GC
show dvlan-tunnel Displays all interfaces enabled for Double
VLAN Tunneling.
PE
show dvlan-tunnel interface Displays detailed information about Double
VLAN Tunneling for the specified interface.
PE
show interfaces switchport Displays switchport configuration. PE
show port protocol Displays the Protocol-Based VLAN information
for either the entire system or for the indicated
group
PE
show switchport protected Displays protected group/port information. PE
show vlan Displays VLAN information. PE
show vlan association mac Displays the VLAN associated with a specific
configured MAC address.
PE
show vlan association
subnet
Displays the VLAN associated with a specific
configured IP subnet.
PE
switchport access vlan Configures the VLAN ID when the interface is
in access mode.
IC
switchport forbidden vlan Forbids adding specific VLANs to a port. IC
switchport general
acceptable-frame-type
tagged-only
Discards untagged frames at ingress. IC
Command Description Mode*
