Spanning Tree Commands 561
Default Configuration
The default port-priority for IEEE STP is 128.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
The priority value must be a multiple of 16.
Example
The following example configures the spanning priority on 1/g5 to 96.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#spanning-tree port-priority
96
spanning-tree priority
Use the spanning-tree priority command in Global Configuration mode to
configure the spanning-tree priority. The priority value is used to determine
which bridge is elected as the root bridge. To reset the default spanning-tree
priority use the no form of this command.
Syntax
spanning-tree priority
priority
no spanning-tree priority
•
priority
— Priority of the bridge. (Range: 0–61440)
Default Configuration
The default bridge priority for IEEE STP is 32768.
Command Mode
Global Configuration mode
