A SERVICE OF

logo

Open as PDF
next previous
448 Configuring Quality of Service
Assigning Bandwidth Settings Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the Bandwidth
Settings page.
Mapping CoS Values to Queues
The CoS to Queue page contains fields for classifying CoS settings to traffic queues. To open the CoS to
Queue page, click Quality of Service→ QoS Mapping→ CoS to Queue in the tree view.
Figure 9-5. CoS to Queue
Table 9-5. Bandwidth Settings CLI Commands
CLI Command Description
traffic-shape committed-rate [committed-burst]
no traffic-shape
Set shaper on egress port. Use no form in
order to disable the shaper.
rate-limit rate
no rate-limit
Limit the rate of the incoming traffic. Use the
no form to disable rate limit.