A SERVICE OF

logo

Open as PDF
next previous
136 Configuring System Information
Deleting a DHCP IPv4 Interface
1
Open the
DHCP IPv4 Interface
page.
2
Click
Show All
.
The
DHCP IPv4 Interface Table
opens.
Figure 6-32. DHCP IPv4 Interface Table
3
Select a DHCP client entry.
4
Select the
Remove
check box.
5
Click
Apply Changes
.
The selected entry is deleted, and the device is updated.
Defining DHCP IPv4 Interfaces Using CLI Commands
The following table summarizes the equivalent CLI commands for defining DHCP clients.
The following is an example of the CLI command:
Table 6-21. DHCP IPv4 Interface CLI Commands
CLI Command Description
ip address
dhcp
[
hostname host-name]
To acquire an IP address on an Ethernet interface from the
Dynamic Host Configuration Protocol (DHCP).
console(config)# interface ethernet 1/e11
console(config-if)# ip address dhcp