2-116
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter2 Commands for the Catalyst 6500 Series SSL Services Module
standby version
standby version
To change the version of the Hot Standby Router Protocol (HSRP), use the standby version command:
standby version {1 | 2}
Syntax Description
Defaults The default HSRP version is 1.
Command Modes Subinterface configuration submode
Command History
Usage Guidelines HSRP version 2 addresses limitations of HSRP version 1 by providing an expanded group number range
of 0 to 4095.
HSRP version 2 will not interoperate with HSRP version 1. An interface cannot operate both version 1
and version 2 because both versions are mutually exclusive. You cannot change from version 2 to version
1 if you have configured groups above 255. Using the no standby version command sets the HSRP
version to the default version, version 1.
If an HSRP version is changed, each group will reinitialize because it now has a new virtual MAC
address.
Examples This example shows how to configure HSRP version 2:
ssl-proxy (config-subif)# standby version 2
ssl-proxy (config-subif)#
1 Specifies HSRP version 1.
2 Specifies HSRP version 2.
Release Modification
SSL Services Module
Release 2.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
SSL Services Module
Release 3.1(1)
The command mode for this command was changed from Proxy-VLAN to
Subinterface.
