2-104
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter2 Commands for the Catalyst 6500 Series SSL Services Module
standby name
standby name
To configure the name of the standby group, use the standby name command. Use the no form of this
command to disable the name.
standby name group-name
no standby name group-name
Syntax Description
Defaults HSRP is disabled.
Command Modes Subinterface configuration submode
Command History
Usage Guidelines The group-name argument specifies the HSRP group.
Examples This example shows how to specifiy the standby name as SanJoseHA:
ssl-proxy (config-subif)# standby name SanJoseHA
ssl-proxy (config-subif)#
Related Commands ip mobile home-agent redundancy (refer to the Cisco IOS Release 12.2 Command Reference)
group-name Name of the standby group.
Release Modification
SSL Services Module
Release 2.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
SSL Services Module
Release 3.1(1)
The command mode for this command was changed from Proxy-VLAN to
Subinterface.
