Displaying and Changing IP-related Information 119
The following prompt is displayed:
Enter DNS Server IP address [196.168.100.3]:
4 Enter a valid Domain Name System (DNS) Server IP address.
Resetting IP
Information to
Factory Default
Settings
You can reset all IP information on the Webcache to factory default
settings using the
initializeConfig command on the IP menu.
To reset IP information to factory defaults:
1 At the Top-level menu, enter:
protocol ip initializeConfig
The following prompt is displayed:
WARNING: This change will lock out all SNMP, Telnet and Web
management access. Do you wish to continue (yes,no)[no]: no
2 Enter yes to reset the IP address for the Webcache.
Pinging Other
Devices
The PING feature allows you to send out a PING request to test whether
devices on an IP network are accessible and functioning correctly. This
feature is useful for testing that the Webcache is installed and set up
correctly, and that your network connections are working.
You can PING other devices on your network using the
ping command
on the IP menu.
To PING a device:
1 At the Top-level menu, enter:
protocol ip ping
The following prompt is displayed:
Enter destination IP address:
2 Enter the IP address of the device that you want to PING.
The Webcache sends a single PING request to the specified device and a
message similar to the following is displayed:
Starting ping, resolution of displayed time is 10
milli-seconds
If the device is accessible and functioning correctly, a message similar to
the following is displayed:
