Filter
Top Products
7
HEADING
6. FUEL BED ARRANGEMENT
6.1 Place the flame baffle onto the burner and push against the
rear tray lip (see Diagram 5).
AR0359
5
Spacer brackets
6.2 Locate the rear panel against the spacer brackets
(see Diagram 3) and slide down so that it locates on the
ledge of the flame baffle (see Diagram 6).
AR0360
6
6.3 Place the log retainer in the two guides as shown in
Diagram 7.
AR2076
7
FOR CLARITY, THE FOLLOWING LOG ARRANGEMENT
DIAGRAMS DO NOT INCLUDE ILLUSTRATION OF THE
RETAINER.
6.4 Locate the front coal between the heat shield and the flame
baffle so that the ends sit flat against the burner skin
(see Diagram 8).
AR0361
8
Heat shield
6.5 Place five of the loose round coals on the front coal so they
lean against the flame baffle, in between the fingers. Place
the two rectangular coals against the reflector panels, one
either side, behind the front row of loose coals
(see Diagram 9).
AR0362
9
6.6 Place four of the loose round coals behind the first row so
that they sit on the fingers of the flame baffle, the two outer
ones should touch the rectangular coals (see Diagram 10).
AR0363
10
6.7 Place the remaining three round coals behind the centre
row so that they touch the back panel (see Diagram 11).
USER INSTRUCTIONS