Filter
Top Products
Dipswitch*
Dip Switch Indications Comments
Cool Airfl ow XXXXCFM View Airfl ow Dipswitches
HT Pump Airfl ow XXXXCFM View Heat Pump Airfl ow Dipswitch
Settings
Cool Air Adj -10%, 0%, 10% View Airfl ow Trim Settings
On-Demand
Dehum
On, Off Activate Dehumidifi cation Feature
* Dipswitch status is not required when the system is set up for 4-wire
communications. It is only displayed when a conventional 24V thermostat
input is active.
Advanced Installer Confi guration Menu
Setup
Parameter Options Comments
Return Air Sens Off, On If Return Air Sensor is fi eld installed, turn On.
Factory Default is Off
Supply Air Sens Off, On If Supply Air Sensor is fi eld installed, turn On.
Factory Default is Off
Reset All Dfl ts No, Yes Resets the Air Handler to the Factory Default
Confi guration by selecting Yes
Choose the System Setting (Cool, Off, Heat,
Em, Auto)
Touch the SYSTEM key to select:
Cool: Thermostat controls only the
cooling system.
Off: Heating and Cooling systems are
off.
Heat: Thermostat controls only the
heating system.
Em: Thermostat controls emergency
heating only.
Auto: Auto Changeover is used where
both heating and cooling may be
required during the same day. Auto
allows the thermostat to automatically
select heating or cooling depending on
the indoor temperature and the selected
heat and cool setpoints. This thermostat
will not allow you to program a confl ict
between Heating and Cooling setpoints.
For setting Auto mode see page 17.
Energy Saving Factory Pre-Program
This touchscreen thermostat is programmed with the energy saving settings shown
in the table below for all days of the week. If this program suits your customer’s
needs, simply touch the Run Schedule key.
Wake Up
(Morning)
Leave For Work
(Day)
Return Home
(Evening)
Go To Bed
(Night)
Heating Program 6:00 AM 70°F 8:00 AM 62°F 5:00 PM 70°F 10:00 PM 62°F
Cooling Program 6:00 AM 75°F 8:00 AM 83°F 5:00 PM 75°F 10:00 PM 78°F
Factory Pre-Programmed heating and cooling schedule for all days of the week
Thermostat Setup
Instructions for changing the programming are in the Homeowner User Guide.
Air Handler User Menus (Cont.)
Fault History (FAULT HIST)
Fault Code Fault Occurred Comments
XXXXXXXXXXXXXXX Days XX Displays up to 6 Faults; Days (XX)
indicates how many days ago the fault
occurred
Clear Faults No, Yes
Unit Info
Parameter Indications Comments
Model Number XXXX-XXXXXXXXXXXXXXXX Unit Model Number
Serial Number XXXXXXXXXXXXXXXXXXX Unit Serial Number (not available
if control is replaced)
Software Vers XXXXXX Control Software Version