Filter
Top Products
31
gram. Press
HOLD
TEMP
. HOLD will be displayed.
Then choose the desired hold temperature by
pressing or . The thermostat will
hold the room temperature at the selected set-
ting until you press
HOLD
TEMP
to start program op-
eration again. This feature is ideal for energy
conservation when the building is unoccupied
for an extended period of time.
• °F/°C CONVERTIBILITY — Press
TIME
FWD
and
TIME
BACK
at the same time until the temperature
display is in
°C (Celsius). To display °F, repeat
the process.
• ADJUSTABLE HEATING AND COOLING
CYCLE TIMES (ANTICIPATION) — If the heat-
ing/cooling system is turning on and off too
often (short cycles) or not often enough (long
cycles), you may want to adjust the anticipation
setting.
An anticipation setting of less than 10 may
cause decreased compressor life.
To adjust HEAT anticipation, press
SET
CLOCK
and
SET
DAY
at the same time. The display will show
HEAT 18. You may select any anticipation
setting from 4 to 40 (note that for add-on heat
pump systems, a minimum anticipation of
10 is recommended). When you adjust antici-
pation, increase or decrease the displayed num-
ber by only one or two digits, then let the system
run for a while to see if the adjustment is
sufficient. If the heat cycles are too short, press
TIME
FWD
to increase the cycle time. If the heat
CAUTION
!