Filter
Top Products
GOLD
CGi-4E Gas-Fired Water Boiler — Boiler Manual
24
Part Number 550-110-711/1108
4d
Failure to prevent low return water temperature to the boiler could cause corrosion of
the boiler sections or burners, resulting in severe personal injury, death or substantial
property damage.
Radiant heating system piping should include a means of regulating the boiler return
water temperature
and the system supply temperature (such as provided by an injec-
tion pumping control
).
Boilerreturnwatertemperaturewillbeadequatelycontrolledusingthemethodsshown
in this manual provided the system supply temperature is relatively constant.
DO NOT apply the methods of this manual if the system is equipped with an outdoor
reset control.
Instead, provide controls and piping which can regulate the boiler re-
turn water temperature
at no less than 130°F regardless of system supply temperature.
ContactyourWeil-McLainrepresentativeforsuggestedpipingandcontrolmethods.
Failure to prevent cold return water temperature to the boiler could cause corrosion
damage to the sections or burners, resulting in possible severe personal injury, death or
substantial property damage.
Piping — low temperature systems
Primary/secondary (preferred)
bypass piping method
Primary/secondary bypass piping is preferred because
the flow rate and temperature drop in the heating
circuit(s) is determined only by the heating circuit
circulator(s).So adjustmentofthebypassvalvesin
the boiler circuit will not cause a change in the heating
circuit rate and temperature distribution.
Figures 20 and 21 show suggested bypass arrangements
using primary/secondary bypass piping (preferred)
for low temperature systems such as radiant heating
systems
or converted gravity systems. For alterna-
tives, see pages 26 through 29.
The bypass valves (items
7a and 7b) provide mixing of
hot boiler outlet water with cooler system return water
— set to assure a minimum return water temperature
(atleast130°F)totheboiler.Setthevalvesasexplained
below.
Temperature gauges
Gauge4a is suggested, but optional on any system.
Gauge
4b is optional on converted gravity systems,
but required on radiant heating systems — to display
the water temperature being supplied to the radiant
tubing.
Gauge
8 is required on all systems to assure the return
water temperature is accurately set for a minimum of
130°F. If this gauge is not available however, adjust the
valves such that the boiler-mounted temperature/pres-
sure gauge reads at least 150°F when the system return
water is cold (approximately 60°F water temperature).
Valve adjustment
(Figures 20 and 21 only)
1. Setthevalveswhilethesystemiscool,settingforthe
coldest expected water temperature (usually 60°F
since the system will often drop to room tempera-
ture between cycles).
2. Startwithvalve
7a fully closed and 7b fully open.
3. Graduallyopenvalve
7a while closing valve 7b until
the temperature at gauge 8 reads 130°F when gauge
4a reads 60°F.
4. Notethatvalve
7a regulates the amount of hot wa-
ter from the boiler supply which mixes with return
water.Valve7b regulates the amount of system water
flowing through the boiler secondary loop.