Filter
Top Products
5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Required
Removing An Old Door
PRE-INSTALLATION
SAFETY GLASSES
FLAT TIP SCREWDRIVER
1/4”, 3/8”, 7/16”, 1/2” &
9/16” WRENCHES
7/16”, 1/2” &
9/16” SOCKET
PHILLIPS HEAD
SCREWDRIVER
RATCHET WRENCH
POWER DRILL
SAWHORSE
GLOVES
3/8”, 7/16” SOCKET
DRIVER
HAMMER
VICE GRIPS
STEP LADDER
TAPE MEASURE
LEVEL
VICE CLAMPS
PENCIL
9/32”, 1/2”, 3/16” & 1/8”
DRILL BITS
Counterbalance spring tension must always be released before any attempt is made to start removing an existing door.
A POWERFUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR FATAL INJURY. TO AVOID
INJURY HAVE A TRAINED DOOR SYSTEMS TECHNICIAN, USING PROPER TOOLS AND INSTRUCTIONS, RELEASE THE
SPRING TENSION.
For detailed information see supplemental instructions “removing an existing door/preparing the opening”. These instructions are
available at no charge from Wayne-Dalton Corp., P.O. Box 67, Mt. Hope, OH 44660, or at www.wayne-dalton.com.
WARNING
APPROVED WINDING BARS
P1
1/4” TORX BIT
NEEDLE NOSE
PLIERS