Filter
Top Products
22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
23
Rear Support
KEEP HORIZONTAL TRACK
PARALLEL AND WITHIN 3/4”
MAXIMUM OF DOOR EDGE,
OTHERWISE DOOR COULD FALL,
RESULTING IN SEVERE INJURY OR
DEATH.
Raise the door until the top section and half
of the next section are in a horizontal position.
Do not raise door any further since rear of
horizontal track is not yet supported.
RAISING DOOR FURTHER CAN
RESULT IN DOOR FALLING AND
CAUSE SEVERE INJURY OR DEATH.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side, just below the second roller on the other
side. This will prevent the door from raising or
lowering while installing the rear support.
Using perforated angle, 5/16” x 1-5/8” hex
head lag screws and 5/16” bolts with nuts
(may not be supplied), fabricate rear support
for horizontal tracks. Attach horizontal tracks to
the rear supports with 5/16”- 18 x 1-1/4” hex
bolts and nuts (may not be supplied). Horizontal
tracks must be level and parallel with door.
NOTE: If rear supports are to be installed over
drywall, use 5/16” x 2” hex head lag screws
and make sure lag screws engaged solid
structural lumber.
NOTE: If an idrive
®
opener will be installed,
position horizontal tracks one hole above level
when securing it to rear supports.
Adjust weather seal (if necessary). Now
permanently attach the weather seal to both
door jambs and header. (Temporarily attached in
PREPARING THE OPENING on page 6-7.) Avoid
pushing weather seal too tightly against face
of door.
PRIOR TO WINDING OR MAKING ADJUSTMENTS
TO THE SPRINGS, ENSURE YOU’RE WINDING IN
THE PROPER DIRECTION AS STATED IN THE
INSTALLATION INSTRUCTIONS. OTHERWISE,
THE SPRING FITTINGS MAY RELEASE FROM
SPRING IF NOT WOUND IN THE PROPER
DIRECTION AND COULD RESULT IN SEVERE OR
FATAL INJURY.
WARNING
WARNING
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Step Ladder
DOOR IN THE
UP POSITION
VERTICAL
TRACK
1/2”- 5/8”
VICE
CLAMPS
DOOR
EDGE
HORIZONTAL TRACK
WARNING