Filter
Top Products
18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
18
none
Torsion Spring Assembly
IMPORTANT: RIGHT AND LEFT HAND IS
ALWAYS DETERMINED FROM INSIDE THE
GARAGE LOOKING OUT.
NOTE: Identify the springs provided as either
right hand wound (red winding cone), which
goes on the LEFT HAND SIDE or left hand
wound (black winding cone), which goes on
the RIGHT HAND SIDE.
Facing the inside of the door, lay the torsion
tube on the floor. Lay the spring with the
black color coded winding cone and the
black color coded cable drum, at the right
hand end of the tube. Lay the spring with the
red color coded winding cone and the red
color coded cable drum, at the left hand end
of the tube.
NOTE: The set screws used on all torsion
counterbalance winding cones and cable
drums, are now colored red. DO NOT identify
right and left hand by the set screw color.
Slide the nylon center bushing onto the
torsion tube followed by the springs and
cable drums. The nylon center bushing,
springs and cable drums must be positioned,
as shown.
With assistance, pick up the torsion
assembly and slide one end of the tube
through one end bearing bracket. Lay the
torsion tube into the center bearing bracket
and slide the other end of the tube into the
opposite end bearing bracket. Position the
torsion tube so that equal amounts of the
tube extend from each end bearing bracket.
LEFT HAND
CABLE DRUM
RED
RIGHT HAND WOUND RED
WINDING CONE LEFT HAND SIDE
RIGHT HAND CABLE
DRUM BLACK
TORSION
TUBE
LEFT HAND WOUND BLACK
WINDING CONE RIGHT HAND SIDE
NYLON CENTER
BRACKET BUSHING
LEFT HAND CABLE
DRUM RED
RIGHT HAND WOUND
RED WINDING CONE
LEFT HAND SIDE
NYLON CENTER
BRACKET BUSHING
RIGHT
HAND
CABLE
DRUM
BLACK
TORSION
TUBE
LEFT HAND WOUND
BLACK WINDING CONE
RIGHT HAND SIDE
TORSION
ASSEMBLY
CENTER
BRACKET
EQUAL
SPACING
END
BEARING
BRACKET
TORSION
ASSEMBLY