Filter
Top Products
24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
�
�
Side Lock
(4) 1/4”- 20 X 11/16”
SELF DRILLING SCREWS
1/8”
Power Drill
7/16” Socket
Driver
Tape Measure
Pull Rope
NO. 6 SCREW EYE
PULL ROPE
BOTTOM BRACKET
PULL ROPE
Install the side lock on the second section of
the door. Secure the lock to the section with
(4) 1/4”- 20 x 11/16” self drilling screws.
Square the lock assembly with the door section
and align with the square hole in the vertical
track. The side lock should be spaced in
approximately 1/8” from the section edge.
IMPORTANT: SIDE LOCKS MUST BE
REMOVED OR MADE INOPERATIVE IN THE
UNLOCKED POSITION IF AN OPERATOR IS
INSTALLED ON THE DOOR.
NOTE: After completing this step, continue with
step 12 on page 14.
1/8”
DO NOT INSTALL PULL ROPES
ON DOORS WITH ELECTRIC
OPERATORS. CHILDREN MAY
BECOME ENTANGLED IN THE
ROPE CAUSING SEVERE OR FATAL
INJURY.
Measure and mark the jamb approximately
48” to 50” (1220 to 1270 mm) from floor on
the right or left side of door. Drill 1/8” pilot
hole for No. 6 screw eye. Install the No. 6
screw eye. Tie the pull rope to the No. 6 screw
eye and to the bottom bracket as shown.
WARNING
Power Drill
1/8” Drill Bit