Filter
Top Products
H1 Readout of the setup data from EEPRO
(Data in EEPROM contents, which have been changed at the local site, are read out together with data in
EEPROM set at shipment from the factory.)
1. Push
S
E
T
,
CL
and
TE
ST
buttons of the remote controller at the same time for 4 seconds or more. 1
(Corresponded with No. in Remote controller as shown below picture)
∗ When group operation, the header indoor unit address is displayed at the first time. In this time, the CODE
No. (DN)
is displayed.
The fan of the second indoor unit operates and the louver starts swinging if any.
2. Every pushing [Unit, Louver
U
NIT L
OU
VE
R
] button, the indoor unit address in the group are displayed successively. 2
Specify the indoor unit No. to be replaced.
3. Using the set temperature / buttons, the CODE No. (DN) can be moved up and down one by one. 3
4. First change the CODE No. (DN) from to . (Setting of filter sign lighting time)
Make a note of the SET DATA displayed in this time.
5. Next change the CODE No. (DN) using the set temperature / buttons.
Also make a note of the SET DATA.
6. Repeat item 5. and made a note of the important SET DATA as shown in the below table.
∗ to )) are provided in the CODE No. (DN). On the way of operation, CODE No. (DN) may skip.
7. After finishing making a note, push
TE
ST
button to return to the usual stop status. 4
(Approx. 1 minute is required to be able to use the remote controller.)
Minimum requirements for CODE No.
Capacity of the indoor unit is necessary to set
the revolutions of the fan.
4
3
1
2
TEMP.
O
N
/
O
F
F
S
E
T
TIME
TE
ST
FIL
TER
RE
S
E
T
CL
S
AV
E
S
WIN
G/
FI
X
VENT
U
NIT L
OU
VE
R
CODE No.
UNIT
No.
R.C.
No.
TIMER
S
E
T
M
O
D
E
FA
N
SET DATA
SETTING
CODE No. (DN)
11
12
13
14
Contents
Indoor unit capacity
Refrigerant line address
Indoor unit address
Group address
FILE NO. SVM-12004
– 61 –