Filter
Top Products
– 148 –
No.
Part name
Electric parts
box assembly
Procedure
6) Take off fixing screw (1 position) of the electric
parts base, and then pull out the electric parts
base toward you.
7) Pull out Tc sensor and Tcj sensor from sensor
holder of the heat exchanger. After replacement
of the parts, incorporate two sensors without
mistake as shown in the right figure.
(Tube is attached to Tcj sensor.)
8) After replacement of the parts, set a trap so that
water does not enter in the electric parts assem-
bly. (Incomplete process for lead wires may
cause water leak.)
Remarks
Tjc sensor position
(Tube is attached to Tcj sensor.)
TC sensor
position
Fixing screw
Pipe
holder
FFFixing
screw
Fixing
screw
Fixing
screw
1) Remove shaft of the side grille from the air
conditioner body. (First remove the left shaft and
then other shafts while sliding the side grille left
and right.)
1) Perform work of item .
2) Remove pipe holder at rear side of the main
body.
3) Take off fixing screws (2 pcs.) at the left side of
the end plate of the heat exchanger.
4) Take off two fixing screws of the heat exchanger
holder (right), and then remove the heat ex-
changer holder (right).
5) Take off fixing screw at lower right side of the
heat exchanger.
6) Remove the heat exchanger from the rear main
body by lifting it upward.
Side grille
Heat exchanger