Page 14 SMD Series Dehumidifying Dryers
Safety 2
2-1 Work Rules
Install, operate, and maintain this equipment according to
applicable work and safety codes for your location. This includes
OSHA, CE, NEC, CSA, SPI, and many other local, national, and
international regulations. Obey these specific work rules:
Read and follow the instructions in this manual before
installing, operating, or maintaining any equipment.
Additional copies are available from Sterling.
Only qualified persons should work on, or with, this
equipment.
Work only with approved tools and devices.
Disconnect and lock out power while working on this
equipment.
2-2 Tools and Equipment Needed
You’ll need the following:
• Hand tools
• Fork lift or overhead lift
• Wire, conduit, and fittings for wiring runs (if receptacle is not
already in place)
• Mounting bolts with nuts and washers
2-3 Mechanical Installation
Dryers may be mounted on a stand, or a mezzanine. Be sure it is
securely attached and additional bracing is used if necessary. The
sections on the following pages explain general installation rules.
Read manual thoroughly before installing dryer.
Use approved safety straps or chains to lift the
dryer at the marked lifting points.