Filter
Top Products
4 –Pump 38-Station Controllers Chapter 4: Operation 28 of 44
Reviewing and Adjusting Basic Station Settings
The 4-pump, 38-station controller has a “Station Operator” screen for each station, as shown
below. This screen enables you to review and adjust all basic settings for the station.
To reach the “Station Operator” screen, complete the following steps:
1. Go to the “Station Status” screen, if needed. To reach this screen from any other
screen, touch STATION STATUS button.
2. Touch and hold the icon for the station, until the controller either prompts for the
password or displays the “Station Operator” screen. Once you have entered the
password (if needed), the “Station Operator” screen appears.
Figure 12: “Station Operator” Screen
Buttons in white are settings that you can adjust at this screen. Boxes in black are for display
only. If a pump assignment or purge time can be changed from operator screen, this must be
done at the “Station Setup” screen.