Filter
Top Products
4 –Pump 38-Station Controllers Chapter 3: Installation 18 of 44
Figure 5: “Station Operator” Screen Before Setup
3. On the “Station Operator” screen (Figure 5), touch the STATION SETUP button. The
“Station Setup” screen opens.
Figure 6: “Station Setup” Screen
4. On the “Station Setup” screen (Figure 6), adjust settings as required. Touching any box
that appears in red (for “disabled”) toggles it to green (for “enabled”), and vice versa.
Touching any white box gives you a keypad to enter a new value.
Keypad entry works as with many ATM machinesthe first digit you enter initially
appears to the right of the decimal point and moves to the left as you enter more digits.
You do not need to use the decimal point. Use CLR to erase any mistakes. Use ENT to
enter the value. The keypad disappears, and the “Station Setup” screen shows the new
value in the selected white box.
Touching RESET TO DEFAULTS in the lower right of the screen changes all the
settings for this station back to their factory defaults.
See pp. 35–37 for details on the options and their default settings.