Filter
Top Products
4 –Pump 38-Station Controllers Chapter 3: Installation 19 of 44
5. As appropriate, setup the rest of the stations using either of the following methods:
• Use the PREVIOUS or NEXT buttons to navigate to other stations. Touch
PREVIOUS to go to the previous “Station Setup” screen, or touch NEXT to go
to the next “Station Setup” screen.
Setting Up Pumps
Before starting the system, you must define several settings for each pump, such as how
quickly to shut it down when it is not in use. This section first discusses how to use the
controller’s menu system to configure pumps. The table on page 37 discusses the individual
choices. In order to setup up the pumps properly, perform the following:
1. Go to the “Pump Status“ screen if needed. To reach this screen from any other screen,
touch PUMP STATUS button. The “Pump Status” screen appears:
Figure 7: “Pump Status” Screen
2. Touch the icon for the pump you want to set up, and hold it for several seconds. The
“Pump Setup” screen opens.