Filter
Top Products
e Check the Presser Foot
Your presser foot _s held m place by a Foot Holder. Each presser foot
merely snaps on the foot holder, which is seldom removed.
If you need to remove or attach the foot hoJder, here is what you do:
To Remove:
Foot
screw
To Remove:
Turn the screw toward the back of
the machine. Use the large screw
driver.
To Attach:
Presser bor_
To Attach:
1. Match the hote in the foot
holder with the threaded hole
m the presser bar.
2. Fit the foot holder screw into
the hole.
3. Tighten the screw by turning It
toward you.
o Change the Presser Foot
Use the correct presser foot for the stitch you wish to sew. Consult the Stitch Pattern
Chart and the detailed directions for sewing with the various presser feet.
To snap off:
UPiDow_
needle
position
utton
Presser
foot
lever
To Snap Off the Presser Foot:
burton_
J
t. Press the Up/Down Needle Position Button to raise
the needle to its highest position.
2. Raise the presser foot.
3. Press the red button on the back of the foot holder,
The presser foot will drop off.
To snap on:
,- _j
To Snap On the Presser
Foot:
1. Set the Pressure ad-
justing ]ever at "3",
2. Place the presser foot
so the horizontal pin
on the foot is just
under the groove of
the foot holder.
NOTE:
3, Lower the presser
fool holder to lock
the presser foot in
place,
If you do not hear the presser foot snap in place, press down on the presser
foot holder firmly until you hear the snap.
15