Sears 385.17724 Sewing Machine User Manual


 
IMPORTANT SAFETY
nNSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use.
Read all instruction before using this sewing machine.
DAN G E _- To reducethe risk of electric shock:
t. An appliance should never be left unattended when plugged in. Always
unplug this appliance from the electric outlet immediately after using
and before cleaning.
2. Always unplug before relamping. Replace bulb with same type rated
15 Watts.
3. Do not reach for the appliance that has fallen into water. Unplug
immediately.
4. Do not place or store appliance where it can fall or be pulled into a tub
or sink. Do not place {n or drop into water or other liquid.
WAR Ni NG- To reduce the risk of burns, fire, electric shock,
or miury to persons.
t.
2_
3.
Do not allow to be used as a toy. Close attention is necessary when this
appliance is used by or near children.
Use this appliance only for its intended use as described in this manuat.
Use only attachments recommended by the manufacturer as contained in
this manual.
Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into
water. Return the appliance to the nearest authorized dealer or service
center for examination, repair, electrical or mechanical adjustment.
4. Never operate the appliance with any air opening blocked. Keep
ventilation openings of the sewing machine and foot controller free from
accumulation of tint, dust, and loose cloth.
5. Never drop or Insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
8. To disconnect, turn all controls to the off ('0") position, then remove
p!ug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the
cord,
10. Keep fingers away from all moving parts. Special care is required
around the sewing machine needle.
11. Always use the proper needle ptate. The wrong plate can cause the
needle to break.
12. Do not use bent needles.
13. Do not pull or push fabric while stitching.
It may deflect the needle causing _t to break.
14. Switch the sewing machine off ("O") when making any adjustment in
the needle area, such as threading needle, changing needle, threading
bobbin, or changing presser foot, and the like.
15. Always unplug the sewing machine from the electrical .outlet when
removing covers, lubricating, or when making any other adjustments
mentioned in the instruction manual.
SAVE THESE INSTRUCTIONS