Filter
Top Products
40 DOCA0005EN-04
Front panel display and meter setup iEM3100 / iEM3200 / iEM3300 series user manual
The parameters listed below are the only ones for which you set a numerical value (if the parameter is
available on your device):
• Date
• Time
• Pick Up Value for an overload alarm
• Voltage Transformer (VT) Primary
• Current Transformer (CT) Primary
• Password
• Address of the meter
To modify a numerical value:
1. Use the down button to modify the selected digit.
2. Press OK to shift to next digit. Modify the next digit, if needed, or press okay to move to the next
digit. Continue to move through the digits until you reach the last digit then press OK again to
confirm the new parameter value.
If you enter an invalid setting for the parameter, when you press OK after setting the left-most
number, the cursor shifts back to the right-most number so you can enter a valid value.
Example: configuring a numeric value
To set the password:
1. Enter configuration mode and press the down button until you reach Password then press OK to
access the password configuration.
2. Press the down button to increment the selected digit or press OK to move to the next digit to the
left. When you reach the left-most digit, press OK to move to the next screen. Press OK again to
save your changes.
Canceling an entry
To cancel the current entry, press the ESC button . The change is canceled and the screen
reverts to the previous display.
Configuration mode menus
The diagrams below show the configuration navigation for each device.
Related topics
• See “Modifying parameters” on page 39 for instructions on how to change settings.