Sanyo SAP-K12AP Air Conditioner User Manual


 
15
1. For safety, be sure to turn the air conditioner off
and also disconnect the power before cleaning.
Or it may cause electric shock.
2. Never sprinkle water on the indoor unit and the
outdoor unit for cleaning because it can cause an
electric shock.
3. Volatile liquid (e.g. thinner or gasoline) will
damage the air conditioner. (So wipe the units
with a dry soft cloth, or a cloth slightly moistened
with water or cleanser.)
CAUTION
Fig. 5
Fig. 6a
Fig. 6b
Fig. 4a
Fig. 4b
1. Take off the front panel
Push in both ends of grooves to the shown position
beside at the same time by the arrow direction.
(Fig. 4a, 4b)
3. Put on front panel
Insert the supports on both ends of panel into groove,
and put the mid rotating shaft in groove, cover the
panel cover according to arrow direction and cover
well. (Fig. 6a,6b)
5.1 Clean the Front Panel
(Make sure to take it off before cleaning)
2. Washing
Clean with a soft brush, water and neutral detergent,
and then to dry it with a clean soft cloth. (Fig. 5)
Do not use hot water which temperature
above 45°C to prevent fade or
deformation.
NOTE
5.2 Cleaning the Air Filters
(Recommended once every 3 months)
1. There are microcomputer components
and circuit diagram on the LCD of front
panel.
2. After taking off the filter, some metal
edges and the fins are sharp and may
cause injury if handled improperly; be
especially careful when you clean these
parts.
3. If dust is much more around the air
conditioner, the air filters should be
cleaned more often.
4. The internal coil and other components
of the outdoor unit must be cleaned
every year. Consult your dealer or
service center.
NOTE
5. CLEAN AND CARE
Operation and Maintenance