Filter
Top Products
14
.
When using the remote control unit, always point the
unit’s transmitter head directly at the air conditioner’s
receiver. (Fig. 3)
(Indoor unit)
Air conditioner
Remote control unit
Fig. 3
1. Slightly to press the place with , along the
arrowhead direction to push the back cover of
wireless remote control. (Fig. 1)
2. Take out the old batteries. (Fig. 1)
3. Insert two new AAA1.5V dry batteries, and pay
attention to the polarity. (Fig. 2)
4. Attach the back cover. (Fig. 2, procedure 4)
4.7 How to Install Batteries
If the wireless remote control is lost or broken, please
use the manual switch button. At this time, the unit
will run at the “AUTO” mode, but the temperature and
fan speed cannot be changed. (Fig. 4)
To open the panel, the manual switch is located on
the displayer box. The operation was shown as below:
• Turn “ON” the Unit:
At unit turned off, press the button, the unit will run
at Auto mode immediately. The microcomputer will
accord to the indoor temperature to select (Cooling,
Heating or Fan) and obtain the comfortable effect.
• Turn “OFF” the Unit:
At unit turned on, press the button, the unit will stop
working.
Manual switch
Fig. 4
Fig. 1
1
2
Fig. 2
Sketch map for
changing batteries
3
4
• The batteries last about six months. Replace the
batteries when the remote control unit’s display
fails to light, or when the remote control cannot be
used to change the air conditioner’s settings.
• When changing the batteries, do not use the old
or different batteries, Use two fresh leak-proof type
-AAA alkaline batteries, otherwise, it can cause the
malfunction of the wireless remote control.
• If the wireless remote control will not be used for
more than one month, please take them out, and
don't let the leakage liquid damage the wireless
remote control.
• It should be placed at where is 1m away from the
TV set or stereo sound sets. If the wireless remote
control can not operate normally, please take
them out, after 30s later and reinsert, if they can’t
normally run, please change them.
• The remote control signal can be received at a
distance of up to about 4meter.
NOTE
4.9 Emergency Operation
4.8 Using the Remote Control Unit
(Transmitter head)
Receiver
FAN
OPER
SWING
AM
C
ON
O
N
/
O
F
F
F
A
N
T
EM
P
-
T
EM
P
+
M
O
D
E
T
I
M
E
-
C
A
N
C
E
L
T
I
M
E
+
S
W
I
N
G
S
L
E
E
P
T
-
O
N
T
-
O
F
F
C
L
O
C
K
o
4. OPERATION OF WIRELESS REMOTE CONTROL UNIT
Operation and Maintenance