Sanyo SAP-K12AP Air Conditioner User Manual


 
9
.
Press to begin or stop indoor fan from blowing indoor components
to dry. This function applicable to “COOL” & “DRY” mode only. In
“AUTO” & “FAN”, “BLOW” function can not be set up and there is
no “BLOW” displaying.
Press this button will turn ON / OFF the display of indicator light.
TEMP button
BLOW button
SLEEP button
LIGHT button
Press to quickly cool or heat the room with intense cool or hot air.
TURBO button
CLOCK Button
SWING Button
For details, see “SLEEP MODE” (P.g 12). When you press this
button in the“DRY” or “COOL” mode, the mark appears in the
display, and the remote control unit will automatically adjust the set
temperature to save energy.
Press to see set temperature or indoor temperature which show on
the indicator lamp according to customer requirement.
: Display the presetting temperature.
: Display the indoor ambient temperature (5 seconds)
: Current displaying status will not be changed.
No Icon : Default to display the pesetting temperature.
To set the air swing direction which circurlarly change as:
OFF
When the guide louver start to swing up and down, if turn off
the Swing, the air guide louver will stop at the current
position. (refer P.g 13 for more detail)
Use this button to set the clock.
How it Works?
Press clock button, signal blink and display. Within 5 seconds,
the value can be adjusted by pressing “+” or “-” button, if press this
button continuously for 2 seconds and above, in every 0.5 seconds,
the value on ten place of Minute will be increased 1. During
blinking, repress the Clock button, signal will be constantly
displayed and it denotes the setting succeeded. After powered on,
12:00 is defaulted to display and signal will be displayed. If there
is signal be displayed that denotes the current time value is
Clock value, otherwise it is a Timer value.
4.2 Remote Control Unit Functions (Continued)
AUTO
: The air conditioner automatically decides the fan speeds.
: Low fan speed.
: Medium fan speed.
: High fan speed.
FAN SPEED selector
button
NOTE
It will display the ambient temperature for 5 seconds,
After 5s later, then will back to display the presetting
temperature.
NOTE
4. OPERATION OF WIRELESS REMOTE CONTROL UNIT
Operation and Maintenance
AUTO