Sanyo SAP-K12AP Air Conditioner User Manual


 
13
During “COOL” mode, if start this function, the unit will run at
super-high fan speed to cool quickly so that the ambient temp.
approachs the preset temp. as soon as possible.
How it works?
It's a special selective button for the users , who are not
accustomed to the light at sleeping.
Setting “OFF ” the displayer indicator light
How it works?
“LIGHT”
Operation
How it works?
“LOCK”
Operation
Press “+” and “-” buttons simultaneously to Lock / Unlock the
keyboard. If the remote controller is locked, the will be
displayed on it, inwhich case, press any button, the mark will
flicker for three times. If the keyboard is unlocked, the mark
will disappear.
Setting “ON” the displayer indicator light
To cancel the light function, the mark will disapper on the
remote controller screen. In which case, the displayer indicator
light will be off if the unit receives this signal.
4. OPERATION OF WIRELESS REMOTE CONTROL UNIT
Operation and Maintenance
How it works?
“SWING”
Operation
About Swing Up and Down
1. Press swing up and down button continuously more than 2s,
the main unit will swing back and forth from up to down, and
then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
2. Under swing up and down mode, when the status is
switched from off to , if press this button again 2s later,
status will switch to off status directly; if press this button
again within 2s,the change of swing status will depend on
the circulation sequence stated below:
About switch between Fahrenheit and Centigrade.
Under status of unit off, press “MODE” and “-” buttons
simultaneously and release both button immediately will switch
in °C and °F.
How it works?
“ °F ” / “ °C ”
Operation
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.
How it works?
Power Failure
During Operation
OFF
4.6 Using of the “Special”
Features (Continued)
“TURBO”
Operation
When setting the light function, the mark will display on the
remote controller screen by pressing this button. In which case,
the displayer indicator light will be on if the AC receives this
signal.
How it works?