Filter
Top Products
Unit Display and Operation Selector
REMOTE CONTROL
receiver
This section picks up infrared signals from the remote control unit
(transmitter).
Operation selector
ON position This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
OFF position Switch the selector to the OFF position if you are not going to use
the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
TEST position This position is used only when servicing the air conditioner.
•
To operate in the TEST position, first select DRY, COOL, or HEAT
mode with the selector in the ON position, and then switch the
selector to the TEST position. However, the air conditioner will
not operate when set to the TEST position if it has been stopped
by setting to the OFF position.
•
During TEST mode, the OPERATION lamp and timer lamp flash,
and remote control operation does not work.
CAUTION
Do not set at the TEST position for normal operation.
OPERATION lamp This lamp lights when the system is in the continuous DRY,
COOL, FAN and HEAT mode.
TIMER lamp This lamp lights when the system is being controlled by the timer.
OPERATION
TIMER
ON
OFF
TEST
OPERATION lamp
Operation selector
Remote control receiver
INDOOR UNIT
TIMER lamp
IMPORTANT
Avoid using radio equipment
such as mobile phones near
(within 1 m of) the indoor unit.
Some radio equipment may
cause the unit to malfunction.
If the trouble occurs, disconnect
power and restart the air
conditioner after a few minutes.
8 OI-202-08EG
oi202000