Filter
Top Products
Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace
22
INSTALLATION
Note: The logs must not be in the unit.
3) Insert the back brick panel by carefully
slipping it between the back wall of the
firebox and the rear log bracket.
OPTIONAL BRICK
PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
2) Attach the 2 Rear Brick Retaining clips to
the rear wall. Loosen the screws in the top
and rear wall of the firebox and slide the
retaining clips into position (tight against
the firebox top) and then tighten the screws.
4) Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.
5) Slide the Top Brick Panel into position and
slide the Top Brick Retaining clips so that
they hold the Top Brick Panel in place and
tighten down the screws.
LOG SET INSTALLATION
NOTE: If you will be installing the optional
Brick Panels, install the Brick Pan-
els prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite around the firebox
base.
Notch
Bracket
Bracket
A) 02-57
B) 02-61
Vermiculite
Vermiculite
Vermiculite
A) 02-57
B) 02-61
The "02" refer
numbers (i.e. 02-57)
are molded into the
rear of each log.
Read the instructions below
carefully and refer to the dia-
grams. If logs are broken do
not use the unit until they are
replaced. Broken logs can in-
terfere with the pilot operation.
The gas log kit (Part # 431-930) contains
the following pieces:
A) 02-57 Rear Log 902-250
B) 02-61 Middle Cross Log 902-254
C) 02-60 Front Left Cross Log 902-253
D) 02-58 Rear Left Log 902-251
E) 02-59 Front Right Cross Log 902-252
F) Embers 902-156
G) Vermiculite 902-179/21
3) Place the Log
A) 02-57 on the rear log
support pins with the flat side to the back.
4) Place Log
B) 02-61 on the front right side
of the burner. Push the back of the log
against the 2 brackets with the notch on the
bottom right side of the log fitting into the
right side of the grate.
5) Position Log C) 02-60 across the cutouts in
Logs A) 02-57 and B) 02-61 with the notch
on the left side of the log fitting into the 2nd
grate tab.
Cutouts
2nd Grate Tab
C) 02-60
A) 02-57
B) 02-61