Filter
Top Products
Regency
®
L676E Direct Vent Gas Fireplace
28
INSTALLATION
BRICK PANEL INSTALLATION
IMPORTANT: Must install 1 set of brick panels. The operation of this unit without the brick panels is prohibited.
Dangerous operating conditions may occur if the panels are broken.
Handle with care. DO NOT FORCE INTO POSITION.
Interior Brick Panel Installation:
1) Remove the glass door.
a. Release the 2 door latches on the left and right side at the top of
the fi rebox.
b. Swing the door out from the top and release the hinges on the left
and right side of the door by lifting them up.
Latch
c. Place the door on a soft surface to prevent scratching.
2) Unwrap the brick panels from the protective wrapping.
Note: The logs must not be in the unit.
3) Remove the 2 brick panel clips on the inside left and right side of the
fi rebox by removing the screw.
Hinge
Door
Latch Location
Screw
Brick
Panel
Clip
4) Place the 2 small back brick panels at the base of the fi rebox on the
left and right side of the rear log tray.
Note: The left and right side back brick panels are different.
Right Side Back
Brick Panel
Left Side Back
Brick Panel
Left Side
Back Brick
Panel
Right Side
Back Brick
Panel
INSTALLATION